changes to make EPCS flash config working

boards/uniboard2/libraries/unb2_board/quartus/unb2_board.qsf

@@ -32,7 +32,9 @@ set_global_assignment -name MIN_CORE_JUNCTION_TEMP 0
 #set_global_assignment -name MIN_CORE_JUNCTION_TEMP "-40"
 set_global_assignment -name MAX_CORE_JUNCTION_TEMP 100
 set_global_assignment -name DEVICE_FILTER_SPEED_GRADE FASTEST
-set_global_assignment -name ERROR_CHECK_FREQUENCY_DIVISOR 256
+#set_global_assignment -name ERROR_CHECK_FREQUENCY_DIVISOR 256
+set_global_assignment -name ERROR_CHECK_FREQUENCY_DIVISOR 4
+set_global_assignment -name ENABLE_OCT_DONE OFF
 set_global_assignment -name POWER_PRESET_COOLING_SOLUTION "23 MM HEAT SINK WITH 200 LFPM AIRFLOW"
 set_global_assignment -name POWER_BOARD_THERMAL_MODEL "NONE (CONSERVATIVE)"
 set_global_assignment -name PARTITION_NETLIST_TYPE SOURCE -section_id Top
@@ -42,14 +44,22 @@ set_global_assignment -name ENABLE_CONFIGURATION_PINS OFF
 set_global_assignment -name ENABLE_NCE_PIN OFF
 set_global_assignment -name ENABLE_BOOT_SEL_PIN OFF
 set_global_assignment -name STRATIXV_CONFIGURATION_SCHEME "ACTIVE SERIAL X4"
+#set_global_assignment -name STRATIXV_CONFIGURATION_SCHEME "ACTIVE SERIAL X1"
+set_global_assignment -name STRATIXII_CONFIGURATION_DEVICE EPCQL1024
 set_global_assignment -name USE_CONFIGURATION_DEVICE ON
 set_global_assignment -name CRC_ERROR_OPEN_DRAIN ON
 set_global_assignment -name OUTPUT_IO_TIMING_NEAR_END_VMEAS "HALF VCCIO" -rise
 set_global_assignment -name OUTPUT_IO_TIMING_NEAR_END_VMEAS "HALF VCCIO" -fall
 set_global_assignment -name OUTPUT_IO_TIMING_FAR_END_VMEAS "HALF SIGNAL SWING" -rise
 set_global_assignment -name OUTPUT_IO_TIMING_FAR_END_VMEAS "HALF SIGNAL SWING" -fall
-set_global_assignment -name ACTIVE_SERIAL_CLOCK FREQ_100MHZ
-set_global_assignment -name USER_START_UP_CLOCK ON
+
+set_global_assignment -name CONFIGURATION_VCCIO_LEVEL 1.8V
+set_global_assignment -name ON_CHIP_BITSTREAM_DECOMPRESSION ON
+#set_global_assignment -name ACTIVE_SERIAL_CLOCK FREQ_12_5MHZ
+set_global_assignment -name ACTIVE_SERIAL_CLOCK FREQ_25MHZ
+#set_global_assignment -name ACTIVE_SERIAL_CLOCK FREQ_100MHZ
+
+set_global_assignment -name USER_START_UP_CLOCK OFF
 
 set_global_assignment -name DEVICE_FILTER_PACKAGE FBGA
 set_global_assignment -name DEVICE_FILTER_PIN_COUNT 1932
@@ -70,12 +80,6 @@ set_global_assignment -name ROUTER_CLOCKING_TOPOLOGY_ANALYSIS ON
 set_global_assignment -name PHYSICAL_SYNTHESIS_REGISTER_RETIMING ON
 set_global_assignment -name ROUTER_TIMING_OPTIMIZATION_LEVEL MAXIMUM
 
-# Remote Upgrade:
-#set_global_assignment -name STRATIXIII_UPDATE_MODE REMOTE
-#set_global_assignment -name STRATIXIII_CONFIGURATION_SCHEME "ACTIVE SERIAL"
-#set_global_assignment -name USE_CONFIGURATION_DEVICE ON
-#set_global_assignment -name STRATIXII_CONFIGURATION_DEVICE EPCS128
-
 
 # Pass compile stamps as generics (passed to top-level when $UNB_COMPILE_STAMPS is set)
 if { [info exists ::env(UNB_COMPILE_STAMPS) ] } {